These objects are filtered out when you upload products from the drawing into the LindabEshop. The Model Checker checks the drawing after ventilation objects which do not fulfill the demands to be a real product. Optimize Fittings allows the user to absorb short pieces of duct to optimize the production. This function allows the user to set a specific length to a new or existing round or rectangular duct. With Manage Ducts you can cut ducts into standard lengths and insert connectors and flanges.
The Update Properties function allows MagiCAD to update MagiCAD objects with additional information. This function allows the user to import non-generic, will sayreal products into an existing MagiCAD Duct Series or to create a new Duct Series with Lindab products. The Ribbon palette is available from AutoCAD 2010 or newer versions. Both types of interface contain full functionality. The CADvent Plug-in contains of 2 possibilities to access the commands. Now you can launch MagiCAD including the CADvent Plug-in. Then close the dialog by pressing the Close button. Enter your contact details and press Activate, the green tick confirms the activation. Selection includes certain translations and local settings for the production such as standard duct lengths and flange types:Īt the end of the installation process you will be asked to register the software. During the installation you will be asked to select a market area.
In the next dialog the installation path is shown, push Install to start the installation. Select the AutoCAD versions you want to install on and push Next: In the next dialog you will be asked on which AutoCAD platforms you want to install the CADvent Plug-in. If you have an earlier version of CADvent Plug-in installed will be prompted to uninstall the existing version first through the Windows Control Panel. NOTE: You need to have local administrator rights to install the Plug-in on your computer.ĭownload the installation file and save it on your computer for later installation or install it by pushing the Run button. The Plug-in supports Windows XP 32-bit, Windows Vista 32- and 64-bit and Windows 7 32- and 64-bit.ĭownload and install the Lindab CADvent Plugin.exe from the download link below: The CADvent Plug-in supports MagiCAD 2011.4 which runs on AutoCAD 2008 to AutoCAD 2012 on 32-bit computers and AutoCAD 2009 to 2012 on 64-bit computers including AutoCAD Verticals. The latest version of the CADvent Plug-in can be downloaded from The Lindab CADvent Plug-in was developed to support CADvents advanced production orientated features on top of MagiCAD using the production orientated objects in MagiCAD.ĬADvent Plug-in features including CADvent properties, duct cutting and flanges, order optimization, reporting for Bill-of-Materials, piece-labelling and Lindab webshop connection where available.
Manual for Lindab CADvent Plug-in for MagiCAD
8įunctionality of the Lindab CADvent Plug-in. Manual for Lindab CADvent Plug-in for MagiCAD. Table of Content CADvent Plug - in for MagiCAD.